![]() Verify that the cables are 1/4 inch balanced.Make sure batteries in the receiver are fresh.If audio is distorting anywhere in the signal chain, it will be distorted even if the PSM300 system is not overloading. Check levels going in and out of the mixer.Check the volume levels at the P3T transmitter and verify that the meter is not reaching the overload indicator.The MixMode knob on the bodypack adjusts the blend between the audio from channel 1 and channel 2. Note: The channel faders on most mixers do not affect the volume of the monitor/auxiliary sends.Ä®ach monitoring mix is transmitted on a separate channel to the P3R receiver. ![]() Each of these mixes are sent to separate channels on the P3T transmitter. In this example, a vocal microphone is plugged into the mixer channel.Īdjust the signal levels to send to the monitor/auxiliary outputs, each of which corresponds to a separate monitoring mix. â Mixer ChannelÄ®ach mixer channel controls audio processing and routing for a single audio source. Consult the user guide for your mixer for detailed signal routing options. The following scenario demonstrates a generic signal path for monitoring mixes, and may not reflect the routing for all mixer types. In live sound applications, the engineer creates a separate mix to send to the performer by routing the input signals to specified mixer outputs, usually called Monitor or Auxiliary outputs. The mix that performers hear on stage is usually different than the mix heard by the audience. When operating in stereo mode, this knob adjusts the left/right balance.When operating in MixMode, this knob blends channels 1 and 2 into a single mix.Illuminates when tuned to an active transmitter group and channel Turns the receiver on/off and adjusts master headphone volume level See battery life table for more information. Indicates when receiver is on, remaining battery life, and when power-save mode is active. A group scan finds the group with the most open channels and selects the first available channel in that group. Note: A channel scan selects the best channel in the current group. Sends and receives sync data between the receiver and transmitter Press and hold to edit the channel, then press to scroll when display flashes.Press and hold to edit the group, then press to scroll when display flashes.Shows group, channel, and MixMode settings Refer to the section on adjusting gain and listening volume for information on how to use this icon. Indicates the input sensitivity setting (corresponds to the Aux/Line switch on the rear panel) Indicates whether the audio sent to the receiver is a single or two-channel mix (corresponds to the Stereo-MX/Mono switch on the rear panel). The direction of the sync is shown as Tx>Rx (transmitter sends frequency to receiver) or Tx ![]() To lock or unlock the controls, press and hold the group and channel buttons until the lock icon appears/disappears.Īppears after a successful sync between the transmitter and receiver. channels, and remains blank in other regions Note: the TV indicator only applies to U.S.A. Mixers or other professional audio devicesĬonnect outputs to additional PSM systems or other audio devicesĬonnect to mixer outputs or other audio sources for monitoring by the performersĬonnect the supplied ¼ wave antenna, directional antenna, or a Shure PA411 antenna combinerÄisplays selected group and channel settings and the corresponding television channel Sends a summed audio mix to both receiver channelsĪdjust the input sensitivity using the following as a connection reference: Aux (-10 dBV):Ĭonsumer audio devices, such as computers or portable media players Sends a two-channel stereo mix to the receiver Note: Sync data is sent through the IR sync windowÄisplays audio, RF, and system informationĬonnect the supplied Shure PS24 external power supply Press to synchronize the transmitter and receiver to the same group and channel Sends and receives group/channel data to sync receivers with the transmitter Adjusts the level of the incoming audio signal
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |